Verifying the configuration – H3C Technologies H3C WX5500E Series Access Controllers User Manual

Page 195

184

# Enable LLDP globally.

system-view

[SwitchB] lldp enable

# Enable LLDP on GigabitEthernet1/0/1. (You can skip this step because LLDP is enabled on ports
by default.) Set the LLDP operating mode to Tx.

[SwitchB] interface gigabitethernet 1/0/1

[SwitchB-GigabitEthernet1/0/1] lldp enable

[SwitchB-GigabitEthernet1/0/1] lldp admin-status tx

[SwitchB-GigabitEthernet1/0/1] quit

Verifying the configuration

# Display the global LLDP status and port LLDP status on Switch A.

[SwitchA] display lldp status

Global status of LLDP: Enable

The current number of LLDP neighbors: 2

The current number of CDP neighbors: 0

LLDP neighbor information last changed time: 0 days,0 hours,4 minutes,40 seconds

Transmit interval : 30s

Hold multiplier : 4

Reinit delay : 2s

Transmit delay : 2s

Trap interval : 5s

Fast start times : 3

Port 1 [GigabitEthernet1/0/1]:

Port status of LLDP : Enable

Admin status : Rx_Only

Trap flag : No

Polling interval : 0s

Number of neighbors: 1

Number of MED neighbors : 1

Number of CDP neighbors : 0

Number of sent optional TLV : 0

Number of received unknown TLV : 0

Port 2 [GigabitEthernet1/0/2]: