H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 215)

204
[DeviceD-GigabitEthernet1/0/2] mvrp enable[DeviceD-GigabitEthernet1/0/2] quit
Verifying the configuration
1. Verify the normal registration mode configuration.
Use the display mvrp running-status command to display the local MVRP VLAN information to
verify whether the configuration takes effect.
# Check the local VLAN information on Device A.
[DeviceA] display mvrp running-status
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet1/0/1]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default),
----[GigabitEthernet1/0/2]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default),
----[GigabitEthernet1/0/3]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default), 20,
The output shows that: ports GigabitEthernet 1/0/1 and GigabitEthernet1/0/2 have learned
only VLAN 1 through MVRP; port GigabitEthernet 1/0/3 has learned VLAN 1 and dynamic VLAN
20 created on Device B through MVRP.
# Check the local VLAN information on Device B.