H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 209)

198
Step Command Remarks
5. Configure the Leave timer. mrp timer leave timer-value
Optional.
The default setting is 60
centiseconds.
6. Configure the Periodic timer. mrp timer periodic timer-value
Optional.
The default setting is 100
centiseconds.
Table 26 shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
• If you set a timer to a value beyond the allowed value range, your configuration will fail. To do that,
you can change the allowed value range by tuning the value of another related timer.
• To restore the default settings of the timers, restore the Join timer first, followed by the Leave and
LeaveAll timers.
Table 26 Dependencies of the Join, Leave, and LeaveAll timers
Timer Lower limit Upper limit
Join 20 centiseconds Half the Leave timer
Leave Twice the Join timer LeaveAll timer
LeaveAll Leave timer on each port 32760 centiseconds
You can restore the Periodic timer to the default at any time.
Enabling GVRP compatibility
CAUTION:
•
MVRP with GVRP compatibility enabled can work together with STP or RSTP, but cannot work together
with MSTP. When MVRP with GVRP compatibility enabled works with MSTP, the network might operate
improperly.
• When GVRP compatibility is enabled for MVRP, H3C recommends disabling the Period timer.
Otherwise, the VLAN status might frequently change when the system is busy.
MVRP can be compatible with GVRP. When the peer device supports GVRP, you can enable GVRP
compatibility on the local end, so that the local end can receive and send MVRP and GVRP protocol
packets at the same time.
To enable GVRP compatibility:
Step Command Remarks
1. Enter system view system-view N/A
2. Enable GVRP
compatibility mvrp gvrp-compliance
enable
By default, GVRP compatibility is disabled.