H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 180)

169
Verifying the configuration
Use the display gvrp local-vlan command to display the local VLAN information that GVRP maintains on
ports. For example:
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 1/0/1 of Device A.
[DeviceA] display gvrp local-vlan interface gigabitethernet 1/0/1
Following VLANs exist in GVRP local database:
1(default)
The output shows that information about VLAN 1 is registered through GVRP, but static VLAN information
about VLAN 2 on the local device and dynamic VLAN information about VLAN 3 on Device B are not.
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 1/0/1 of Device B.
[DeviceB] display gvrp local-vlan interface gigabitethernet 1/0/1
Following VLANs exist in GVRP local database:
1(default)
The output shows that information about VLAN 1 is registered through GVRP, but static VLAN information
about VLAN 3 on the local device and dynamic VLAN information about VLAN 2 on Device A are not.