H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 140)

129
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VLAN view. vlan vlan-id N/A
3. Associate an IP subnet with
the VLAN. ip-subnet-vlan [ ip-subnet-index ]
ip ip-address [ mask ]
The IP subnet or IP address to be
associated with a VLAN cannot be a
multicast subnet or a multicast address.
4. Return to system view. quit N/A
5. Enter interface view or port
group view.
• Enter Ethernet interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregation
interface view:
interface bridge-aggregation
interface-number
• Enter port group view:
port-group manual
port-group-name
Use one of the commands.
• The configuration made in Ethernet
interface view applies only to the
port.
• The configuration made in port
group view applies to all ports in
the port group.
• The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
6. Configure port link type as
hybrid.
port link-type hybrid By default, all ports are access ports.
7. Configure the hybrid ports
to permit the specified IP
subnet-based VLANs to
pass through.
port hybrid vlan vlan-list { tagged
| untagged }
By default, a hybrid port allows only
packets from VLAN 1 to pass through
untagged.
8. Associate the hybrid ports
with the specified IP
subnet-based VLAN.
port hybrid ip-subnet-vlan vlan
vlan-id By default, no IP subnet-based VLAN is
associated with a port.
Configuration example
Network requirements
As shown in Figure 39 , the hosts in the office belong to different IP subnets 192.168.5.0/24 and
192.168.50.0/24.
Configure Device C to transmit packets over separate VLANs based on their source IP addresses.