H3C Technologies H3C S5820X Series Switches - Manual (Page 69)

59
1. Plug the DB-9 female connector to the serial port of the console terminal or PC.
2. Connect the RJ-45 connector to the console port of the switch.
NOTE:
•
Identify the mark on the console port to ensure that you are connecting to the correct port.
• The serial port on a PC does not support hot swapping. When you connect a PC to a powered-on switch,
connect the DB-9 connector of the console cable to the PC before connecting the RJ-45 connector to the
switch.
• When you disconnect a PC from a powered-on switch, Disconnect the DB-9 connector of the console
cable from the PC after disconnecting the RJ-45 connector from the switch.
Setting terminal parameters
To configure and manage the switch, you must run a terminal emulator program on the console terminal,
for example, a PC.
The following are the required terminal settings:
• Bits per second—9,600
• Data bits—8
• Parity—None
• Stop bits—1
• Flow control—None
• Emulation—VT100
To set terminal parameters, for example, on a Windows XP HyperTerminal:
1. Select Start > All Programs > Accessories > Communications > HyperTerminal, and in the
Connection Description dialog box that appears, type the name of the new connection in the Name
text box and click OK.
Figure 62 Connection description of the HyperTerminal