H3C Technologies H3C S5820X Series Switches - Manual (Page 14)

4
S5820X-26S panel views
Front panel
Figure 1 S5820X-26S front panel
(1) SFP+ port (2) SFP+ port LED
(3) 10/100/1000Base-T auto-sensing Ethernet port (4) 10/100/1000Base-T Ethernet port LED
(5) Management Ethernet port (6) Console port
(7) USB port (8) Port LED mode switching button
(9) System status LED (SYS) (10) Port mode LED
(11) Seven-segment LED (12) ACT LED for the management Ethernet port
(13) LINK LED for the management Ethernet port
Rear panel
Figure 2 S5820X-26S rear panel
(1) Power module slot 1 (2) Power module slot 2
(3) Fan tray slot 1 (4) Fan tray slot 2
(5) Grounding screw (auxiliary grounding point 2)
NOTE:
•
The S5820X-26S switch comes with the power module slots empty and the power filler modules as
accessories. You can install one or two power modules for your S5820X-26S switch as needed. In this
figure, two LSVM1AC650 AC power modules are installed.
• The switch also comes with the fan tray slots empty. You must install two fan trays for the S5820X-26S for
adequate heat dissipation, and their models must be the same. In this figure, two LSWM1FANSC fan
trays are installed.