H3C Technologies H3C S5820X Series Switches - Manual (Page 50)

40
Figure 35 Connect the grounding cable to a grounding strip
(1) Hex nut (2) OT terminal
(3) Grounding post (4) Grounding strip
NOTE:
•
H3C recommends that you use the primary grounding point or auxiliary grounding point 1 because the
grounding cable and grounding screw provided with the switch are applicable only to these two
grounding points.
• To use auxiliary grounding point 2, you must prepare a grounding cable yourself. The connection
method is the same as connecting to the other two grounding points.
Connecting the grounding cable for the S5820X-28S or S5820X-28C switch
The S5820X-28S and S5820X-28C switches have a grounding point (with a grounding sign) on their
rear panels.
To connect the grounding cable:
1. Remove the grounding screw from the rear panel of the switch chassis.
2. Attach the grounding screw to the OT terminal of the grounding cable.
3. Use a screwdriver to fasten the grounding screw into the grounding screw hole.
(2) (3) (4) (1)