H3C Technologies H3C S5820X Series Switches - Manual (Page 38)

28
Installing the switch in a 19-inch rack
Installation methods
You can install the H3C S5820X Switch Series in a 19-inch rack by using load-bearing mounting brackets,
as shown in Figure 17 , Figure 18 , and Figure 19 .
Figure 17 Install an S5820X-26S switch in a 19-inch rack
Figure 18 Install an S5820X-28S switch in a 19-inch rack
Figure 19 Install an H3C S5820X-28C switch in a 19-inch rack
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and fix the switch to the rack with mounting brackets.
Table 22 Install an S5820X-26S switch in the rack
Mounting bracket
position
Installing the
mounting brackets
Installing the chassis rails and
slide rails
Installing the
switch
• Rear mounting (near
the power modules)
• Front mounting (near
the network ports)
See " Attaching the
mounting brackets and
chassis rails to the switch
chassis ."
Required.
See "
Attaching the mounting
brackets and chassis rails to the
switch chassis ” and “ Attaching the
slide rails to the rack ."
See " Installing
the switch in
the rack
."
CAUTION:
The depth of the rack for the S5820X-26S switch must be 1000 mm (39.37 in).