H3C Technologies H3C S10500 Series Switches - Manual (Page 247)

236
2. Set the state of each member port in the service loopback group.
Figure 77 Set the state of each member port in a service loopback group
NOTE:
Every time a new port is assigned to a service loopback group, the system resets the state of the member
ports in the service loopback group according to the process described previously.
Configuring a service loopback group
Follow these steps to configure a service loopback group:
To do… Use the command… Remarks
Enter system view system-view —
Create a service loopback
group and specify its
service type
service-loopback group number
type { multicast-tunnel | tunnel } *
Required
Enter Layer 2 Ethernet
interface view interface interface-type
interface-number
—
Assign the Ethernet
interface to the specified
service loopback group
port service-loopback group
number
Required
By default, a port does not belong to any
service loopback group.
You can perform this command on
different ports to assign multiple ports to a
service loopback group.