H3C Technologies H3C S10500 Series Switches - Manual (Page 176)

165
GVRP configuration task list
Complete these tasks to configure GVRP:
Task Remarks
Configuring GVRP functions Required
Configuring the GARP timers Optional
NOTE:
•
GVRP configuration made in Ethernet interface view or Layer 2 aggregate interface view takes effect on
the current interface only; GVRP configuration made in port group view takes effect on all the member
ports in the group.
• GVRP configuration made on a member port in an aggregation group takes effect only after the port is
removed from the aggregation group.
Configuring GVRP functions
Before enabling GVRP on a port, you must enable GVRP globally. In addition, you can configure GVRP
only on trunk ports, and you must assign the involved trunk ports to all dynamic VLANs.
Follow these steps to configure GVRP functions on a trunk port:
To do… Use the command… Remarks
Enter system view system-view ––
Enable GVRP globally gvrp
Required
Globally disabled by default.
Enter Ethernet interface
view or Layer 2
aggregate interface view
interface interface-type
interface-number
Enter Ethernet
interface view,
Layer 2
aggregate
interface view, or
port group view
Enter port group view
port-group manual
port-group-name
Required
Use either command.
Configure the link type of the ports as trunk port link-type trunk
Required
Access by default.
Assign the trunk ports to all VLANs port trunk permit vlan all
Required
By default, a trunk port is
assigned to VLAN 1 only.
Enable GVRP on the ports gvrp
Required
Disabled by default.
Configure the GVRP registration mode on the
port gvrp registration { fixed |
forbidden | normal } Optional
normal by default.