H3C Technologies H3C S10500 Series Switches - Manual (Page 131)

120
Follow these steps to assign an access port (in interface view) or multiple access ports (in port group view)
to a VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter Layer 2
Ethernet
interface view
interface interface-type
interface-number
Enter Layer 2
aggregate
interface view
interface
bridge-aggregation
interface-number
Enter
interfac
e view
or port
group
view
Enter port group
view port-group manual
port-group-name
Required
Use any command.
• The configuration made in Layer 2 Ethernet
interface view applies only to the port.
• The configuration made in port group view
applies to all ports in the port group.
• The configuration made in Layer 2 aggregate
interface view applies to the aggregate interface
and its aggregation member ports. If the system
fails to apply the configuration to the aggregate
interface, it stops applying the configuration to
aggregation member ports. If the system fails to
apply the configuration to an aggregation
member port, it skips the port and moves to the
next member port.
Configure the link type of
the ports as access
port link-type access
Optional
By default, all ports are access ports.
Assign the access ports to a
VLAN
port access vlan vlan-id
Optional
By default, all access ports belong to VLAN 1.
NOTE:
•
Before you assign an access port to a VLAN, create the VLAN.
• In VLAN view, you can assign only Layer 2 Ethernet interfaces to the VLAN.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Layer 2
Ethernet interface view, and Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a trunk port to one or multiple VLANs:
To do… Use the command… Remarks
Enter system view system-view —
Enter Layer 2
Ethernet
interface view
interface
interface-type
interface-number
Enter interface
view or port
group view
Enter Layer 2
aggregate
interface view
interface
bridge-aggregation
interface-number
Required
Use any command.
• The configuration made in Layer 2 Ethernet
interface view applies only to the port.
• The configuration made in port group view