H3C Technologies H3C S10500 Series Switches - Manual (Page 132)

121
To do… Use the command… Remarks
Enter port
group view port-group manual
port-group-name
applies to all ports in the port group.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply the
configuration to the aggregate interface, it
stops applying the configuration to
aggregation member ports. If the system
fails to apply the configuration to an
aggregation member port, it skips the port
and moves to the next member port.
Configure the link type of the ports
as trunk
port link-type trunk
Required
By default, all ports are access ports.
Assign the trunk ports to the
specified VLANs port trunk permit vlan
{ vlan-id-list | all } Required
By default, a trunk port carries only VLAN 1.
Configure the PVID of the trunk
ports
port trunk pvid vlan
vlan-id
Optional
By default, the PVID is VLAN 1.
NOTE:
•
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
• After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to
configure the trunk port to allow packets from the PVID to pass through, so that the egress port can
forward packets from the PVID.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view, and Layer 2 aggregate interface view) or port group view.
Follow these steps to assign a hybrid port to one or multiple VLANs:
To do… Use the command… Remarks
Enter system view system-view —