H3C Technologies H3C S10500 Series Switches - Manual (Page 218)

207
To do... Use the command... Remarks
Configure an SVLAN marking action to
replace the local SVLAN ID with a
foreign SVLAN ID
remark service-vlan-id vlan-id
Return to system view quit
Create a QoS policy and enter QoS
policy view
qos policy policy-name Required
Associate the class with the behavior
classifier tcl-name behavior
behavior-name
Required
Repeat this step to create other
class-behavior associations.
Configuring the customer-side port
Follow these steps to configure the customer-side port:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet interface view
interface interface-type
interface-number
—
Configure the port as a trunk port port link-type trunk
Required
The default link type of an Ethernet
port is access.
Assign the port to the local SVLANs
port trunk permit vlan { vlan-id-list |
all }
Required
By default, a trunk port is in only
VLAN 1.
Apply the uplink policy configured
for the customer-side port to the
incoming traffic
qos apply policy policy-name
inbound
Required
Skip this step if you have not
configured an uplink policy for
replacing SVLAN tags.
Apply the downlink policy
configured for the customer-side
port to the outgoing traffic
qos apply policy policy-name
outbound
Required
Configuring the network-side port
Follow these steps to configure the network-side port:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet interface view
interface interface-type
interface-number
—
Configure the port as a trunk port port link-type trunk
Required
The default link type of an Ethernet
port is access.
Assign the port to local SVLANs
port trunk permit vlan { vlan-id-list |
all }
Required
By default, a trunk port is in only
VLAN 1.