Mac-based vlan configuration example, Network requirements – H3C Technologies H3C S10500 Series Switches User Manual
Page 139
128
To do...
Use the command...
Remarks
Disable the PVID of the port
from forwarding packets with
unknown source MAC
addresses that do not match
any MAC address-to-VLAN
entry
port pvid disable
Optional
By default, when a port receives a
packet with an unknown source MAC
address that does not match to any
MAC address-to-VLAN entry, it
forwards the packet in its PVID.
NOTE:
After you use the mac-vlan trigger enable command to enable dynamic MAC-based VLAN assignment,
H3C recommends that you configure the vlan precedence mac-vlan command to preferentially match
VLANs based on MAC addresses, and do not configure the vlan precedence ip-subnet-vlan command to
preferentially match VLANs based on IP subnet-VLAN entries, because the vlan precedence
ip-subnet-vlan command does not take effect in this case.
Follow these steps to configure dynamic MAC-based VLAN:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter Ethernet
interface view
interface interface-type
interface-number
Enter
interface
view or port
group view
Enter port group
view
port-group manual
port-group-name
Use either command.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in port group
view applies to all ports in the port
group.
Configure the link type of the ports
as hybrid
port link-type hybrid
Required
By default, all ports are access ports.
Configure the hybrid ports to permit
packets from specific MAC-based
VLANs to pass through
port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
By default, a hybrid port only permits the
packets of VLAN 1 to pass through.
Enable the MAC-based VLAN
feature
mac-vlan enable
Required
Disabled by default.
Configure 802.1X/MAC/portal
authentication or any combination
For more information, see
Security Command
Reference.
Required
MAC-based VLAN configuration example
Network requirements
As shown in
•
GigabitEthernet 1/0/1 of Device A and Device C are each connected to a meeting room. Laptop
1 and Laptop 2 are used for meetings and might be used in either of the two meeting rooms.
•
Different departments own Laptop 1 and Laptop 2. The two departments use VLAN 100 and VLAN
200 respectively. Each laptop must be able to access only its own department server, no matter
which meeting room it is used in.
•
The MAC address of Laptop 1 is 000D-88F8-4E71, and that of Laptop 2 is 0014-222C-AA69.