Port isolation configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S12500-X Series Switches User Manual
Page 70: Ethernet link aggregation configuration task list, Configuring an aggregation group
59
Task Command
Display isolation group information
display port-isolate group [ group-number ] [ | { begin |
exclude | include } regular-expression ]
Port isolation configuration example
Network requirements
As shown in
, LAN users Host A, Host B, and Host C are connected to Ten-GigabitEthernet
1/0/1, Ten-GigabitEthernet 1/0/2, and Ten-GigabitEthernet 1/0/3 on the device, respectively. The
device connects to the Internet through Ten-GigabitEthernet 1/0/4.
Configure the device to provide Internet access for the hosts, and isolate them from one another at Layer
2.
Figure 14 Network diagram
Configuration procedure
# Create isolation group 2.
[Device] port-isolate group 2
# Assign Ten-GigabitEthernet 1/0/1, Ten-GigabitEthernet 1/0/2, and Ten-GigabitEthernet 1/0/3 to
isolation group 2.
[Device] interface ten-gigabitethernet 1/0/1
[Device-Ten-GigabitEthernet1/0/1] port-isolate enable group 2
[Device-Ten-GigabitEthernet1/0/1] quit
[Device] interface ten-gigabitethernet 1/0/2
[Device-Ten-GigabitEthernet1/0/2] port-isolate enable group 2
[Device-Ten-GigabitEthernet1/0/2] quit
[Device] interface ten-gigabitethernet 1/0/3
[Device-Ten-GigabitEthernet1/0/3] port-isolate enable group 2
Internet
Host A
Host B
Host C
XGE1/0/2
XGE1/0/1
XGE1/0/3
XGE1/0/4
Device