beautypg.com

Setting the statistics polling interval, Forcibly bringing up a fiber port – H3C Technologies H3C S12500-X Series Switches User Manual

Page 20

background image

9

Setting the statistics polling interval

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter Ethernet interface

view.

interface interface-type
interface-number

N/A

3.

Set the statistics polling

interval.

flow-interval interval

By default, the interface statistics
polling interval is 300 seconds.

To display the interface statistics collected in the last polling interval, use the display interface command.
To clear interface statistics, use the reset counters interface command.

Forcibly bringing up a fiber port

As shown in

Figure 2

, a fiber port uses separate fibers for transmitting and receiving packets. The

physical state of the fiber port is up only when both transmit and receive fibers are physically connected.
If one of the fibers is disconnected, the fiber port does not work.
To enable a fiber port to forward traffic over a single link, you can use the port up-mode command. This

command brings up a fiber port by force, even when no fiber links or optical modules are present. If one

fiber link is present and up, the fiber port can forward packets over the link unidirectionally.

Figure 2 Forcibly bring up a fiber port

Correct fiber

connection

When Ethernet

interfaces cannot

be or are not

forcibly brought up

When Ethernet interfaces

are forcibly brought up

The fiber is
disconnected.

Fiber link

XGE1/0/1

XGE1/0/1

Device A

Device B

XGE1/0/1

XGE1/0/1

Device A

Device B

XGE1/0/1

XGE1/0/1

Device A

Device B

The interface is
down.

Packets

Fiber port

Tx end

Rx end

This manual is related to the following products: