beautypg.com

Configuration procedure, Setting the loop detection interval – H3C Technologies H3C S12500-X Series Switches User Manual

Page 158

background image

147

Figure 46 Network diagram

Configuration procedure

1.

Configure Switch A:
# Configure customer-side port Ten-GigabitEthernet 1/0/1 as a trunk port, and assign the port to
original VLANs and translated VLANs.

system-view

[SwitchA] interface ten-gigabitethernet 1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 1 2 3 101 201 301

[SwitchA-Ten-GigabitEthernet1/0/1] vlan mapping 1 translated-vlan 101

[SwitchA-Ten-GigabitEthernet1/0/1] vlan mapping 2 translated-vlan 201

[SwitchA-Ten-GigabitEthernet1/0/1] vlan mapping 3 translated-vlan 301

[SwitchA-Ten-GigabitEthernet1/0/1] quit

This manual is related to the following products: