beautypg.com

Digest snooping configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S12500-X Series Switches User Manual

Page 101

background image

90

Step Command

Remarks

3.

Enable Digest Snooping on
the interface.

stp config-digest-snooping

By default, Digest Snooping is
disabled on ports.

4.

Return to system view.

quit

N/A

5.

Enable Digest Snooping

globally.

stp global config-digest-snooping

By default, Digest Snooping is
disabled globally.

Digest Snooping configuration example

Network requirements

As shown in

Figure 21

, Device A and Device B connect to Device C, which is a third-party device. All

these devices are in the same region.
Enable Digest Snooping on the ports of Device A and Device B that connect to Device C, so that the three
devices can communicate with one another.

Figure 21 Network diagram

Configuration procedure

# Enable Digest Snooping on Ten-GigabitEthernet 1/0/1 of Device A and enable global Digest
Snooping on Device A.

system-view

[DeviceA] interface ten-gigabitethernet 1/0/1

[DeviceA-Ten-GigabitEthernet1/0/1] stp config-digest-snooping

[DeviceA-Ten-GigabitEthernet1/0/1] quit

[DeviceA] stp global config-digest-snooping

# Enable Digest Snooping on Ten-GigabitEthernet 1/0/1 of Device B and enable global Digest
Snooping on Device B.

system-view

[DeviceB] interface ten-gigabitethernet 1/0/1

[DeviceB-Ten-GigabitEthernet1/0/1] stp config-digest-snooping

This manual is related to the following products: