H3C Technologies H3C S12500-X Series Switches - Manual (Page 65)

54
[DeviceA-Bridge-Aggregation1] quit
2. Configure Device B in the same way Device A is configured. (Details not shown.)
Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Dynamic
Loadsharing Type: Shar
System ID: 0x8000, 000f-e267-6c6a
Local:
Port Status Priority Oper-Key Flag
--------------------------------------------------------------------------------
XGE1/0/1 S 32768 1 {ACDEF}
XGE1/0/2 S 32768 1 {ACDEF}
XGE1/0/3 S 32768 1 {ACDEF}
Remote:
Actor Partner Priority Oper-Key SystemID Flag
--------------------------------------------------------------------------------
XGE1/0/1 1 32768 1 0x8000, 000f-e267-57ad {ACDEF}
XGE1/0/2 2 32768 1 0x8000, 000f-e267-57ad {ACDEF}
XGE1/0/3 3 32768 1 0x8000, 000f-e267-57ad {ACDEF}
The output shows that link aggregation group 1 is a Layer 2 dynamic aggregation group and it contains
three Selected ports.
Layer 2 aggregation load sharing configuration example
Network requirements
As shown in Figure 13 :
• Configure two Layer 2 static aggregation groups (1 and 2) on Device A and Device B respectively,
and enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other
end, and VLAN 20 at one end to communicate with VLAN 20 at the other end.
• Configure the load sharing criterion for link aggregation group 1 as the source MAC addresses of
packets and the load sharing criterion for link aggregation group 2 as the destination MAC
addresses of packets to enable traffic to be load-shared across aggregation group member ports.