H3C Technologies H3C S12500-X Series Switches - Manual (Page 169)

158
• IEEE 802.1AB-2009, Station and Media Access Control Connectivity Discovery
• ANSI/TIA-1057, Link Layer Discovery Protocol for Media Endpoint Devices
• DCB Capability Exchange Protocol Specification Rev 1.00
• DCB Capability Exchange Protocol Base Specification Rev 1.01
• IEEE Std 802.1Qaz™-2011, Media Access Control (MAC) Bridges and Virtual Bridged Local Area
Networks-Amendment 18: Enhanced Transmission Selection for Bandwidth Sharing Between Traffic
Classes
LLDP configuration task list
Tasks at a glance
Performing basic LLDP configuration:
• (Required.) Enabling LLDP
• (Optional.) Configuring the LLDP bridge mode
• (Optional.) Setting the LLDP operating mode
• (Optional.) Setting the LLDP re-initialization delay
• (Optional.) Enabling LLDP polling
• (Optional.) Configuring the advertisable TLVs
• (Optional.) Configuring the management address and its encoding format
• (Optional.) Setting other LLDP parameters
• (Optional.) Setting an encapsulation format for LLDPDUs
(Optional.) Configuring CDP compatibility
(Optional.) Configuring DCBX
(Optional.) Configuring LLDP trapping and LLDP-MED trapping
Performing basic LLDP configuration
Enabling LLDP
To make LLDP take effect on specific ports, you must enable LLDP both globally and on these ports.
To enable LLDP:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable LLDP globally. lldp global enable
By default, LLDP is disabled
globally.
3. Enter Layer 2 or Layer 3
Ethernet interface view or
Layer 2 aggregate interface
view.
interface interface-type interface-number N/A