ARAG GCS 3200 - Manual (Page 8)

8
6.3 Job computer fastening
Secure the remote control unit on the back of the machine, close to the control unit and the hydraulic unit.
Respect the mounting direction of the job computer, as indicated in Fig. 6 (connectors shall be facing down).
No other type of assembly is allowed.
Fix the control uni using the 4 bolts fitted into their slots ( a , Fig. 6).
Fig. 6
6.4 Auxiliary input fixing
a
Fig. 7
Place the device inside the control cabin of the farming machine.
Auxiliary input must be positioned after fixing the suitable bracket
a as
indicated on the side.
The bracket must be secured using the supplied screws(Fig. 7).
Make sure bracket is duly fastened.
6.5 Control unit position
The control unit must be fixed with the special brackets supplied and fitted to the unit, positioning it as shown in the manual provided with the assembly.
MAKE SURE TO FOLLOW ALL THE SAFETY INSTRUCTIONS GIVEN IN THE CONTROL UNIT’S MANUAL.
6.6 Hydraulic unit positioning
The hydraulic unit must be fixed with the special brackets supplied and fitted to the unit, positioning it as shown in the manual provided with the unit.
ARAG IS NOT LIABLE FOR ANY DAMAGE RESULTING FROM THE INSTALLATION BY UNSKILLED PERSONNEL. ANY SYSTEM
DAMAGE CAUSED BY A WRONG INSTALLATION AND/OR CONNECTION AUTOMATICALLY VOIDS THE WARRANTY.
CAUTION! DO NOT CONNECT HYDRAULIC UNITS OTHER THAN THE SPECIFIED ONES (SEE ARAG GENERAL CATALOGUE).
ARAG IS NOT LIABLE FOR ANY DAMAGE TO THE PRODUCT, MALFUNCTION ERRORS AND ANY KIND OF RISK IF THE MODULE
IS CONNECTED TO NON ORIGINAL UNITS OR UNITS NOT SUPPLIED BY ARAG.
INSTALLATION