ARAG GCS 3200 - Manual (Page 34)

34
WORK FUNCTIONS
14.2 Spraying data
Displays the data of the current treatment.
Fig. 80
Each time you enter the Job's data function, the ISOBUS system
shows the data of the active job.
- Press on the job number to select and view the desired data.
- Some countings activate ONLY in determined conditions:
tiMe counting
enabled
sprayed
area counting
enabled
distance
travelled
counting
enabled
Master ON
Master ON
+
Rate ON
Master OFF
14.2.1 Data reset
Fig. 81 Fig. 82
Reset ALL displayed data:
In the
Job's data (Fig. 80) screen press G Reset all data (Fig. 81).
Reset only one value:
In the
Job's data (Fig. 80) screen press H Reset data and select the value to be reset (Fig. 82).
14.3 Transducer zero setup
Activate the "zero" calibration procedure of pressure sensor.
Fig. 83
In case a pressure value is displayed despite the absence of pressure
inside the circuit, it is necessary to perform zero setup of the sensor:
Press OK to reset the pressure sensor residual signal.
Bravo 300S automatically quits the procedure and displays the job screen
with the pressure value of
0.0 bar .
Signal out of range! Check transducer
Faulty pressure values detected: check the transducer operation.
If problem persists, check for residual pressure in the system.
14.4 User settings
It accesses the User setting .
Refer to Chap. 13 - User setting - to correctly program all menu items.