ARAG GCS 3200 - Manual (Page 36)

36
USE
15.4 Display
Fig. 85
1 Detected output
2 Set flowrate
3 Speed
4 Tank level (text and graphic)
5 General status
6 Section status:
section ON and Main ON
Section ON and Main OFF
Section OFF
7 Automatic A or manual M operation
8 Pressure
9 Nozzle being used
10 Customizable data
Fig. 86
A * Decreases temporarily the output (par 15.5)
B * Gains access to the management of H2O sections and the main command
(par 15.6)
C * Gains access to the management of the hydraulic functions (par 15.7)
D Selects a job already set (par 13.2)
E Goes back to the previous page of the menu (Fig. 78)
F Selects the manual or automatic operation mode (par 15.9)
G Activates the left foam marker (par 15.10)
H Activates the right foam marker (par 15.10)
I * Activates or deactivates the main command (par 15.11)
J * Increases temporarily the output (par 15.5)
* COMMANDS ONLY WORK IF NO AUXILIARY INPUT DEVICE IS
CONNECTED.
15.5 Temporary increase and decrease of the output
Fig. 87 Fig. 88
Press A (Fig. 87) to decrease the set output value  96 .
Press J (Fig. 88) to increase the set output value  156 .
COMMANDS ONLY WORK IF NO AUXILIARY INPUT DEVICE IS CONNECTED.