ARAG GCS 3200 - Manual (Page 12)

12
8.4 Connection of sensors and other available functions
Fix the connectors to the relevant functions according to the initials indicated in your assembly general diagram (Par. 6.1).
Harness cables are marked with a symbol denoting their functions: please see the table for correct harness instructions.
Use ARAG sensors: use of unsuitable sensors not provided by ARAG automatically voids the warranty.
ARAG is not liable for damages to the equipment, persons, animals or things caused by failure to observe the above instructions.
ITEM MAIN CONNECTION ALTERNATIVE CONNECTION
f Flowmeter -
g Main valve -
M Pressure sensor -
p Control valve -
r Foam marker -
s Speed sensor -
t Filling flowmeter
Pump Protector
X RPM sensor
1 ÷ 7 Section valves -
1 ÷ 13 Section valves (sequential vers.) -
Tab. 5
The "Pump Protector" sensor (Code 4664000.100), when connected to the computer, provides an indication in the event a pump diaphragm breaks
or oil level drops below minimum level.
CAUTION:
Only use the secondary input "T" if the input marked "X" is occupied by another sensor.
Do not use the secondary input "T" if no sensor is connected to the "X" input, as the computer will not detect the Pump
Protector in this configuration.
Instructions for sensor installation are supplied with the products.
The speed sensors listed below can also be used as RPM sensors:
• inductive speed sensor (
Code 467100.086);
• magnetic speed sensor ( Code 467100.100).
- Connection of:
• flowmeter;
• pressure sensor;
• Pump Protector;
• filling flowmeter;
• RPM sensor;
• foam marker.
All ARAG sensors use the same type of connector. Connect the sensor connector to the relevant harness; make sure it is correctly fitted and push it
until locking it.
Fig. 14 Fig. 15
INSTALLATION