ARAG GCS 3200 - Manual (Page 11)

11
8.3 Hydraulic valves connection
CGS3200 can control up to 9 hydraulic functions through double-acting valves.
Fig. 13
• Fix the connectors to the relevant valves according to the initials indicated in your assembly general
diagram (6.1 System recommended composition).
• Position seal (
1) onto connector (2) then connect the latter pressing it fully home (3): during this
operation, take care not to bend the electric contacts.
• Insert screw inside connector, and screw it (
4) until it is tightened.
The function of each switch on the hydraulic function control panel is described below.
Connect the connector marked with "DD" to the pilot valve, and then the other connectors, as specified on the table:
CONTROL MOVEMENT CONNECTOR
Section movement / AUX switch opening
1 - 2 - 3 - 4 - 5 - 6
Opening 1 ÷ 6 A
Closing 1 ÷ 6 C
Boom height
Opening AA
Closing AC
Boom locking
Opening BA
Closing BC
Boom leveling
Opening CA
Closing CC
Tab. 4
INSTALLATION