ARAG Bravo 400S Crop sprayer - Manual (Page 89)

89
"JOB MENU" - F8 MENU
14.8
F8 Menu
Job settings menu

1

2
Fig. 309
1 In the guidance screen, press Menu .
2 Press F8 to view the Settings menu menu (Fig. 310).
Fig. 310
In this screen it is possible to access
several different menus, which can be
useful during spraying:
•
Alarms (par. 10.1.10).
• Working parameters (par. 10.1.11).
• Device status (par. 10.5).
14.8.1 Speed source
Fig. 311
Allows to select the source for speed calculation. Available options:
• GPS
Information concerning speed is received by the GPS, which is connected directly to Bravo 400S.
• Wheel sensor
When this option is enabled, the speed is calculated on the basis of the pulses received by the
speed sensor installed on the wheel.
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
The wheel constant must be entered during the setup procedure (par. 10.1.7).
• GPS and Wheel sensor
When this option is enabled, Bravo 400S uses both sources:
- guidance information and accessory functions are active thanks to the data from the GP;
- the output is set (par. 12.1) with the speed read by the wheel sensor.
• Simulation
Allows to enable speed simulation in order to carry out adjustment tests even when the machine is stationary.
SIMULATION
SPEED


Fig. 312
Edit simulation speed (DEF 6.0 km/h - 3.7 MPH):
F3 ( + ) increase, F5 ( - ) decrease
WARNING: guidance information and all accessory functions
(surface calculation, alignment, etc.) are disabled.
Par.
7.4
Exits the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Increase /
Decrease
of data Scroll
(UP /
DOWN) Enter
selected
character