ARAG Bravo 400S Crop sprayer - Manual (Page 26)

26
10.1.4 Pressure sensor
Fig. 71
• Activation status
To configure the items on this menu, you must enable the pressure sensor
(
Sensor enabled / Sensor enabled - cannot be modified / Sensor disabled).
- Enter the values for the pressure sensor installed on the system.
The table below indicates the values that are automatically set selecting the sensor code.
If the installed sensor is not displayed, select
Other and enter the relevant values.
ARAG PRESSURE SENSOR
Type
Maximum pressure
bar PSI
ARAG 466113.200 20.0 290
ARAG 466113.500 50.0 725
Other 50.0 725
Depending on the basic settings (Flowrate reference sensor, ch. 9), the pressure sensor, once properly set up, can perform different functions:
• Pressure sensor:
the pressure measured by the sensor is used to calculate the spray rate.
• Flowmeter: the pressure sensor displays ONLY the job pressure.
• Both: the pressure sensor displays the job pressure when the machine works within the flowmeter limits.
When the flowmeter operates outside the limits the pressure measured by the sensor is used to calculate the spray rate.
Fig. 72
• Type
Indicate the type of pressure sensor installed.
Fig. 73
• Maximum pressure
The item Maximum pressure can be modified only when the option Other is enabled.
Indicate the full scale of the pressure sensor installed on the system.
ADVANCED SETUP "IMPLEMENT"
Par.
7.4
Exits the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Increase /
Decrease
of data Scroll
(UP /
DOWN) Enter
selected
character