ARAG Bravo 400S Crop sprayer - Manual (Page 24)

24
10.1.2 Flowmeter
Enter the values for the flowmeter installed on the system.
The table below indicates the values that are automatically set when selecting the flowmeter code.
If the installed flowmeter is not displayed, select
Other and enter the relevant values.
Fig. 61
ORION FLOWMETERS WOLF FLOWMETERS
Type
Constant
Minimum
flowrate
Maximum
flowrate Type
Constant
Minimum
flowrate
Maximum
flowrate
pls/l pls/gal l/min GPM l/min GPM pls/l pls/gal l/min GPM l/min GPM
4621xA0xxxx 6000 22710 0.5 0.10 10 2.6 462x 2xxx 1025 3880 2.5 0.7 50 13.2
4621xA1xxxx 3000 11355 1 0.30 20 5.3 462x3xxx 625 2366 5.0 1.3 100 26.4
4621xA2xxxx 1200 4542 2.5 0.70 50 13.2 462x4xxx 250 946 10.0 2.6 200 52.8
4621xA3xxxx 600 2271 5 1.30 100 26.4 462x5xxx 132 500 20.0 5.3 400 105.7
462xxA4xxxx 300 1135 10 2.60 200 52.8 462x7xxx 60 227 40.0 10.6 800 211.3
4622xA5xxxx 150 568 20 5.30 400 105.7
4622xA6xxxx 100 378 30 7.90 600 158.5
Other 625 2366 10 2.60 200 52.8
Fig. 62
• Type
Indicate the type of flowmeter installed.
Fig. 63
• Constant
Indicate the constant of the installed flowmeter.
Fig. 64 Fig. 65
• Minimum flowrate
• Maximum flowrate
The items Minimum flowrate and
Maximum flowrate can be modified
only when the option Other ( Type menu
in Fig. 62) is enabled.
Enable the relevant function on the Alarms menu
(par. 10.1.10) if you want the computer to trigger
an alarm when, during spraying, the flowmeter
rate is outside the set range.
For the procedure to be followed when an
alarm occurs, please refer to par. 16.1 Error
messages.
ADVANCED SETUP "IMPLEMENT"
Par.
7.4
Exits the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Increase /
Decrease
of data Scroll
(UP /
DOWN) Enter
selected
character