ARAG Bravo 400S Crop sprayer - Manual (Page 100)

100
16 MAINTENANCE / DIAGNOSTICS / REPAIRS
16.1 Error messages
MESSAGE ON DISPLAY CAUSE REMEDY WORK MODE
Drive! Machine stopped Main switch ON with machine stopped
• Start the machine
• Move main switch downwards
(position OFF)
Main ON
+
Regulation
AUTO ON
Connection to RCU not detected!
Communication problems between monitor and
control unit (RCU)
• Check condition of connection cables
(and connectors) between monitor and control unit
(par. 5.2)
--
The cables are damaged • Replace the cable --
GPS receiver not connected!
Wrong connection of receiver cable to Bravo400S • Check connection to receiver (par. 5.2) --
The receiver connection cable is damaged • Replace the cable --
The receiver is damaged • Replace the receiver --
Insufficient GPS signal quality!
The position and number of satellites do not
allow a suitable driving precision
• Wait for signal strength to improve --
GPS receiver gives invalid data!
The receiver is establishing a connection to the
satellites
• Wait for connection --
DGPS correction not available!
DGPS signal unavailable in the working area • Disable DGPS correction (par. 10.2.1) --
DGPS connecting • Wait for connection --
Activate pump! Missing flowrate Main switch ON but rate at zero • Start the pump and move the machine
Main ON
+
Regulation
AUTO ON
Minimum tank level reached!
Tank level is lower than the set range value • Fill the tank (par. 14.3) Main ON
Minimum value was not set
correctly
• Check set range value (par. 10.1.9)
Automatic regulation blocked!
Pressure does not reach set value • Increase driving speed
Main ON
+
Regulation
AUTO ON
Limit was not set correctly • Check set limit (par. 10.1.11)
Decelerate! Pressure too high
The pressure exceeds the maximum level
allowed for the nozzle being used
• Decrease driving speed
• Adjust the operating pressure so as to respect
the previously set limits for nozzles in use
• Check set maximum pressure for nozzles in use
(par. 10.1.6) Main ON
Accelerate! Insufficient pressure
The pressure does not reach the minimum value
for the nozzle in use
• Increase driving speed
• Adjust the operating pressure so as to respect
the previously set limits for nozzles in use
• Check set minimum pressure for nozzle in use
(par. 10.1.6) Main ON
CONTINUES
MAINTENANCE / DIAGNOSTICS / REPAIRS