ARAG Bravo 400S Crop sprayer - Manual (Page 11)

11
INSTALLATION
6.5 Hydraulic valves connection
Fig. 13
Bravo 400S can control up to 9 hydraulic functions through double-acting valves.
Fix the connectors to the relevant valves according to the initials indicated in your assembly general diagram (par. 5.1).
• Position seal ( 1 ) onto connector ( 2 ), then connect the latter pressing it fully home ( 3 ):
during this operation, take special care not to bend valve electric contacts.
• Insert screw inside connector, and screw it (
4 ) until it is tightened.
The function of each switch on the hydraulic function control panel is described below.
• Connect the connector marked with "DD" to the pilot valve, and then the other connectors, as specified on the table:
CONTROL MOVEMENT CONNECTOR
Section movement
1 - 2 - 3 - 4 - 5 - 6
Opening 1 ÷ 6 A
Closing 1 ÷ 6 C
Boom height
Opening AA
Closing AC
Boom locking
Opening BA
Closing BC
Boom leveling
Opening CA
Closing CC