7 setup, 1 setup preparation, 2 switching on – ARAG Bravo 400S Crop sprayer User Manual
Page 15: Setup preparation, Switching on
15
7
SETUP
7.1
Setup preparation
Before computer setup, check:
• that all components are correctly installed (control unit and sensors);
• the correct connection to the power source;
• the correct connection of components (control unit and sensors).
Failure to correctly connect system components or to use specified components might damage the device or its components.
7.2
Switching on
Fig. 23
SOFTWARE VERSIONS
Fig. 24
Keep key pressed until Bravo 400S
displays the screen shown in Fig. 23.
The software version is shown
immediately afterwards (Fig. 24).
FIRST DEVICE SWITCHING ON
Fig. 25
Fig. 26
Upon first switching on, after the
software version, Bravo 400S
displays the "Home" (Fig. 25)
screen: press
F8
and enter the
device basic settings
(ch. 9).
ORDINARY SWITCHING ON
Fig. 27
Fig. 28
After the software version, Bravo 400S
displays the Select User prompt
(Fig. 27)
Press
F7
or
F8
to move across the
available items, then press
OK
to
confirm your selection.
At this point, Bravo 400S displays
the "Home" screen (Fig. 28).
SETUP
Par.
Exits the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT)
Delete
selected
character
Increase /
Decrease
of data
Scroll
(UP /
DOWN)
Enter
selected
character