ARAG Bravo 400S Crop sprayer - Manual (Page 47)

47
10.2.4 Tilt calibration procedure
Fig. 164 Fig. 165
Select Tilt calibration procedure and press
OK .
WARNING: To carry out the calibration, the
vehicle must be stationary on a level
surface.
10.2.5 Correction type
Fig. 166
Allows selecting the DGPS (SBAS) differential correction function or Omnistar ® .
- Correction disabled
- DGPS correction enabled:
The SBAS differential correction signal is free of charge and available only in some areas of the world.
This signal allows to obtain a more accurate spraying.
WARNING: this function may be used only in Europe (EGNOS), USA (WAAS) and Japan (MSAS).
- Omnistar ® correction enabled:
Omnistar ® correction signal is available worldwide for a fee and allows to obtain high working accuracy.
WARNING! The differential correction service subscription is not managed by ARAG, but directly by
Omnistar
® .
For more information on the subscription, visit Omnistar ® 's website.
10.2.6 Receiver advanced data
Fig. 167 Fig. 168
Shows the GPS receiver and Omnistar ® correction
data.
To display Omnistar
® select the Region of use in
order to correctly activate the Omnistar ® service.
10.2.7 HDOP alarm
Fig. 169
"HDOP" is the parameter that depends on the position and number of satellites in space that affect the
positional precision of the system (longitude and latitude); the lower the value, the higher is the driving
precision.
The precision alarm is triggered when the value of HDOP measured by the GPS receiver is above the set
limit.
We recommend NOT to set values above 4.0.
ADVANCED SETUP "TRACTOR"
Par.
7.4
Exits the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Increase /
Decrease
of data Scroll
(UP /
DOWN) Enter
selected
character
CONTINUES > > >