5 f5 resume job, Resume job, Resume job) – ARAG Bravo 400S Crop sprayer User Manual
Page 78: Home" menu - f5 resume job
78
13.5
F5
Resume job
Enables procedure for resuming a previously saved job.
1 Press
F5
to resume a previous job, from the list of saved jobs.
As for the function
New job
(par. 13.3), if not previously saved, Bravo 400S asks to save the current job.
2 Select the job among the ones on the list (Fig. 279) and press
OK
to confirm the selection.
2a When the last job is resumed, Bravo 400S provides guidance information by restoring the conditions which were active at the time of saving.
With the
Loading options
screen (enabled in par. 10.3.6), you can choose which information to load (Fig. 280).
3 Check
Spraying settings
in Fig. 281; change them if necessary.
4 Select
and press
OK
to switch to guidance mode.
5 Complete the job (Fig. 282).
1
2
Fig. 279
Fig. 280
2a
In this screen it is possible to enable or disable the information memorized during the last saving
(
Data enabled,
Data disabled).
- Select the data available on the list one at a time and proceed to setting:
• Applied area
when this data is disabled, the relevant counter is reset as well.
• Perimeter
when this data is disabled, the counter of the calculated surface is reset as well.
• Reference lines
• Points of interest (POI)
• Job data
when this data is disabled, all counters will be reset as well;
at job loading a new date and time of spraying begin wil be memorized.
- Select
Start job...
and press
OK
to go to
Spraying settings
.
Fig. 281
3
5
Fig. 282
4
"HOME" MENU - F5 RESUME JOB
Par.
Exits the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT)
Delete
selected
character
Increase /
Decrease
of data
Scroll
(UP /
DOWN)
Enter
selected
character