Amer Networks SS3GR24i - Manual (Page 7)

SS3GR24i/SS3GR48i Layer 3 Switch CLI Reference
1
1
I
NTRODUCTION
The SS3GR24i/SS3GR48i Switch can be managed through the switch’s serial
port, Telnet, or the Web-based management agent. The Command Line
Interface (CLI) can be used to configure and manage the switch via the serial
port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the
CLI. Configuration and management of the switch via the Web-based
management agent is discussed in the User’s Guide.
Accessing the Switch via the Serial Port
The switch’s serial port’s default settings are as follows:
• 9600 baud
• No parity
• 8 data bits
• 1 stop bit
A computer running a terminal emulation program capable of emulating a VT-
100 terminal and a serial port configured as above is then connected to the
switch’s serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the
following screen should be visible. If this screen does not appear, try pressing
Ctrl+r to refresh the console screen.