AEC WD 350 through WD3000 Dehumidifying Dryers - Manual (Page 60)

11. Turn control power ON . The PV LED displays four zeros (
0000
), then displays the
current process air temperature.
Caution!
Do not attempt to run the controller without an output load.
The contactors could be damaged!
12. Press to page through Level 0 control parameters. The PV LED displays codes
indicating the currently selected mode; the SV LED shows the current setting of the
selected parameter. Use and to select a setting.
13. Set Level 0 parameters based on Figure 12 on the following page.
14. Press for at least two seconds to access Level 1 parameters. Set them using the
procedure in the previous step.
Note: You can proceed to Level 2 , but these parameters are read-only. Controllers with optional
communications have user-set variables (unit address and ID) on Level 2 .
15. Turn off the power switch on the graphic display and remove all electrical power to the
dryer.
WDMR and WDFR Series Dehumidifying Dryers Page 59