Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 94)

CHAPTER 8 • BASIC TASKBUILDER FUNCTIONS 93
Figure 8.9 – Error Report
Debugging a Task
Follow the steps below to go through a task step-by-step in Debug mode:
1 Make sure that TaskBuilder configuration is set to Debug (see Chapter 11).
2 Click the button on the toolbar. TaskBuilder will ask for any user-defined values,
then the Debug menu will open on the toolbar.
3 Click the button to execute only the first action.
Each click of the button will cause only the next action to execute, bringing up the Error
Report after each executed action. The currently executing action will be highlighted in red
in the main task window. At any time in the stepping process, you can click to execute
all remaining tasks without stopping. Click to stop execution entirely and return to the
normal editing mode.
Note
If you are debugging a task, switching to a different task will end the debug process.