Email – Wavetronix Command Translator (CMD-DT) - User Guide User Manual
Page 101
100
CHAPTER 9 • TASKBUILDER COMPONENTS
file name cannot be found.
The Email component represents an email to be sent to a particular address containing ei-
ther a new file or information about the completion of a task. It is a destination component
because no actions originate here.
Figure 9.4 – Email Component
The Email component has the following properties:
˽
Subject (Value—String) – Text to insert into the subject line of each email.
˽
Body (Value—String) – Text to insert into the body of each email.
˽
To Address (Value—String) – This is the email address that the messages will be sent
to. For multiple recipients, use a comma to separate the addresses ([email protected],
Note
The system will not verify whether the email address is valid, so you are responsible
for checking that you have entered the correct email address. If the email address is
incorrect, the email will NOT reach the intended recipient.
˽
Address File (Value—String) – This field provides an alternative to the To Address
property. To use an address file, create a simple text file with the email addresses sepa-
rated by a comma (all email addresses must be on the same line). When finished, set
the value of this field to the full path of the text file, or use the Browse button to select
the path. This provides a convenient way to change recipients without modifying the
task.
If you are using TaskBuilder on a machine other than the one with Translator service,
you will need to place the address file in the same directory as the service machine.
˽
From Address (Value—String) – This field contains the address that will be displayed
in the From field of the email. The default value is “[email protected].”