Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 120)

CHAPTER 10 • TASKBUILDER ACTIONS 119
overwritten with the new file.
˽ Remove Source Files? (Value—Yes/No) – Select Yes to delete the local source file after
the file has been uploaded. (In case of error, where the file upload failed, the file will not
be deleted locally). Select No to keep a copy of the file locally.
Data-to-Trip-Time Action
The Data-to-Trip-Time action (see Figure 10.15) represents, in addition to current speed
values, the calculation of a trip time for a linear string of sensors or lanes taken from a set
of data.
Figure 10.15 – Data-to-Trip-Time Action
The Data-to-Trip-Time action has the following properties:
˽ Trip-Time Mapping (Value—TripTimeMap) –For TaskBuilder to work with a variety
of databases, a mapping must be created to show where to find the ID numbers for
sensors and lanes as well as the speed data for the trip-time calculation. Editing this
property will open the Trip Time Mapping sub-window and allow you to create the
map from the dataset to the trip-time values (see Chapter 11).
˽ Trip-Time (Value—TripTime) – The Trip Time property holds the route information for
the trip-time calculation, the order the sensors are in, and the distances between each
sensor. Editing this property will open the Trip Time sub-window, allowing you to cre-
ate and edit a route (see Chapter 11).
Note
Proper use of the Trip Time sub-window will require the Trip Time Mapping prop-
erty to be configured first. A sub-window will inform you if the Trip-Time property is
opened without the mapping being set.
Trip-Time-to-XML Action
The Trip-Time-to-XML action (see Figure 10.16) completes the operation of calculating the
trip time and outputs the trip-time information to an XML file.