Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 32)

CHAPTER 2 • JOB LIST PAGE 31
Log
The Log section displays any information that the service has written to the log. In order to
give you feedback as to the status of the service, the service log displays any log messages
recorded since the last time it began executing. The author of the service will determine
what information to write to the log. There will always be a Starting Service entry, but the
level of detail available may vary from service to service.
Errors
The Errors section displays any errors that the service has written to the error log since the
last time it began executing. The author of the service will determine what information to
write to the log. Any errors are potentially serious and should be investigated.
Properties
The Properties section lets you set information needed from you in order for the service to
operate properly. The information needed will vary from service to service, so each service
will show a different list of settings on this page. Each property will usually have a descrip-
tion string on the right side of the text field that defines what the property is, as shown in
Figure 2.19.
Figure 2.19 – Properties Example Screen
After setting the property values, click the Save button.
Notifications
Click on the Notifications tab to access the Notifications section (see Figure 2.20). This
section allows you to select other users to receive a report via email whenever the service
is completed.
Under the Notify Users section, you can see the users who have already been set up to be
notified, with their username, name, and if they are to be notified in case of a successful
execution of the service, a failed execution, or both. There is also a link to remove the user