Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 44)

CHAPTER 4 • ROUTES PAGE 43
Select either, both, or none of these options, then hit OK. More information about recali-
brating segments can be found later in this chapter.
Note
It is recommended that you manually validate the segments and mappings created
using this feature.
Zoom Options
In many cases, the number of segments in a route will be too many or too narrow to ef-
fectively view all useful information over the entire route. In these cases, the UI supports
zooming into smaller sections of the route. The zoom controls are located in the upper right
of the Edit Route page (see Figure 4.6).
Figure 4.6 – Zoom Options
To zoom in, enter mile marker values into the From and To fields representing the mile
markers to display at the far left and far right of the new display respectively. (The From and
To values must be between or equal to the start and end mile markers for the route.
Once you’ve zoomed in on a route, segments can still be selected and edited (although not
all segments in the route may be visible). In cases where segments extend beyond the zoom
boundaries in either direction, the segments lengths will have a “...” appended to the begin-
ning or end of their length display text to show that the segment continues on beyond the
border of the route graphic.
To return to the full view of the route—cancelling any zoom settings—push the Full View
button within the Zoom Options box.
Route
The primary route definition is displayed as a graphic showing the full length of the route
from the start mile marker to the end mile marker. Figure 4.7 shows a basic route 20 miles
long from MM #1 to MM #21.
Figure 4.7 – Basic Route