Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 23)

22 CHAPTER 2 • JOB LIST PAGE
Note
Storing too many history entries will result in poor performance; the recommended
number of entries is 10–100. This can be adjusted based on the number of defined
jobs and how often they execute. If all entries need to be retained, a recommended
solution would then be to add an email notification for offline management and
archiving.
˽ The Execution list gives the status and start/completion times for each individual ex-
ecution. This list will only appear if you are configuring a job (i.e. you accessed this
screen by clicking on the name of a job on the Job List); if you are adding a new job,
this area will be blank. Clicking on an execution time populates the Details text area
below the table.
˽ The Details text area displays specific information pertaining to each task and action
that was executed. This includes start and end times for each task, along with result
and error information, if appropriate. The text area is populated when you click on an
execution time in the Execution list.
Note
In cases where the job has been run multiple times due to an initial failure, the
results of each attempt will be listed in the
Details text area, one after another. The
status icon will show “success” if any of the retry attempts succeeded; otherwise,
the icon will show “failure.”
Tasks
Click on the Tasks button to access the Tasks section (see Figure 2.7). This section allows
you to select and configure tasks to be executed with the current job.
Note
A task will not run automatically unless an event is added to trigger the job.