Wavetronix Command Translator (CMD-DT) - User Guide User Manual
Page 123
122
CHAPTER 11 • TASKBUILDER SUB-WINDOWS
Note
The properties of both Database components must be set before opening the Data-
base Conversion sub-window; these properties are used to obtain database connec-
tion and they provide table and column information necessary for the mapping to be
created.
If TaskBuilder is unable to connect to one or both databases, a sub-window will alert you
that a connection could not be made. In this case, check the connection properties for the
source and destination databases and make sure the properties were entered correctly. Be-
low is a list of possible connectivity problems:
˽
There was a loss of network connection between the TaskBuilder and the target ma-
chine.
˽
The database was not configured to accept outside connections.
˽
The database was not configured to allow the given username/password combination
to access that particular database or table.
Figure 11.1 – DB Conversion