Wavetronix Click 111 (16-channel Contact Closure Eurocard) (CLK-111) - User Guide - Manual (Page 35)

34 CliCk 111 • User GUIde
Figure 12 – Expert Driver Diagnostics Tab
Click the General button to run diagnostics on the items listed below the button. If a prob-
lem is detected, the program will display a red square next to the item in question. If no
problems are detected, a green circle will appear.
Click Fault Status to check whether any of the buses are indicating a fault condition. If a
fault status is detected, a red square will be displayed next to the channel with the fault, as
well as next to Master. If no problems are detected, a green circle will appear.
Once you have finished, use the menu bar at the top of the screen to save your settings,
return to the Select Driver screen, and more.
˽ The Save menu allows you to save your settings. Select Save to File to save your settings
to a file. Selecting this will open a directory box, allowing you to name your settings
file. This file will always be saved in the Wavetronix folder created when you installed
Click Supervisor, under Wavetronix > ClickHome > Drivers > 111 > User. You can also
select Save to Device to save your settings to your Click 111.
Note
If you do not save your settings to your Click 111, they will be lost the next time you
power the device down.
˽ The Tools menu contains five options for working with your device. Reset > System
power cycles your device, while Reset > Factory Default restores your device to the
settings with which it was shipped. Restore will restore the driver to the settings cur-
rently saved on the Click 111, erasing any unsaved changes. Upgrade can be used to
manually upgrade to the most current firmware for your device. Hex View changes the
view of certain settings in the driver to hexadecimal.