Wavetronix Click 111 (16-channel Contact Closure Eurocard) (CLK-111) - User Guide - Manual (Page 25)

24 CliCk 111 • User GUIde
This parameter selects how the Click 111 maps the incoming sensor outputs to the card’s
outputs. The setting determines the starting sensor channel that will be mapped to the as-
sociated bus channel 1 output.
Example
If you have this parameter set to 3 for bus 1, then sensor channel 3 will be mapped
to output channel 1 on bus 1. And then the card will count up from there: if the bus
has four channels allocated to it, then sensor channel 4 will be mapped to output 2,
sensor channel 5 will be mapped to output 3, and sensor channel 6 will be mapped
to output 4.
Level 1 LEDs
Base channel for bus 1
Base channel for bus 2
Level 2 LEDs
Channel 1
Channel 3
Channel 5
Channel 7
Channel 9
Channel 11
Channel 13
Channel 15
Channel 17
Channel 19
Channel 21
Channel 23
Channel 25
Channel 27
LED off
LED on
Cancel and exit menu
Table 12 – Front Panel Menu Base Channel Settings
See the earlier Navigating through the Menu and the Menu Operation Example sections for
how to configure this parameter.