WallWizard X700CB Manual - Manual (Page 9)

www.closystems.com 9
If the power outlet for TV and X-arm™ is located inside the bellows of X-arm™, follow these
directions.
7-1. Run A/V cables on the left side going over the bottom cross bar, through a cable loop and down
through the cable hole in the back of the X-arm.
7-2. Run the TV power cord over the bottom cross bar, through the right cable loop, under the cable
bar at the back, and up toward the electrical outlet. Secure the power cord to the cable bar
using a zip tie.
7-3. Run the IR receiver cord over the bottom cross bar, through the right cable loop, through the
bellows and down through the cord hole, plugging it into the side of the X-arm™ control box.
7-4. Coil up the excess TV power cord and IR Receiver cord and put a zip tie around them.
7-5. Plug the X-arm™ power cord into X-arm™, run the cord up
through the cable hole and plug it in, gathering the excess with
a cable tie. Place the cord into the space near the cable bar as
shown to the right. Fasten it to the cable bar with another zip tie.
7-6. The AV, power cord, and IR Receiver cords must be long enough
to connect equipment, but not so long that they get caught in X-
arm™ parts. Test this by tilting up, down, and side to side.
7-7. Fasten all cables to the cable bar at the back of X-arm™ using
the provided zip ties.
7-8. Fasten the cables to the bottom cross bar so that they are at least
2” (5 cm) from the center beam. Cut off the excess zip tie.
AV Cables
to TV
AV Cables from
Component
TV Power
Cord
IR Reciever
Plug
AV Cable Loop
Bellows
No Cable
2” (5 cm)
No Cable
2” (5 cm)
Cable Bar
Cable Hole
Bottom Cross Bar
IR Receiver Eye
Center
Beam
TV Power outlet
inside belows.
Cable Tie Anchor
TV Power &
IR Receiver Hook
X-arm power cord