WallWizard X700CB Manual - Manual (Page 6)

www.closystems.com
Concrete Wall Installation
1. Mark anchor locations
1-1. Remove the wall plate from the back of the X-arm™. First loosen the 2 security screws at
the bottom, then lift the wall plate off the X-arm™.
1-2. Hold the wall plate up to the wall where you want the X-arm™
located.
1-3. Level the wall plate.
1-4. Mark the wall in 6 places as shown. Holes should be as far
apart as possible.
2. Install six screw anchors
2-1. Using a 1/2” (13 mm) masonry drill bit, drill 6 holes 2-1/2”
(6,35 cm) deep at the locations drawn in step 1-4.
2-2. Install the 6 anchors as shown with the hinged end facing
toward you.
Both Wood Stud & Concrete Wall Installation
3. Hang the wall plate
3-1. Secure the wall plate to the wall using all
six of the provided black 2-1/2” (6,35 cm) lag
bolts.
4. Hang X-arm™ on the wall
4-1. Hang the X-arm™ on the top edge of the wall plate.
4-2. If needed, slide X-arm™ on the wall plate about 1.5”
(3,81 cm) in either direction to center it in the room.
4-3. Using a philips screw driver, tighten the 2 security
screws on the bottom of the X-arm™.
16” (406.4 mm)
hinge
4.1
4.3