WallWizard X700CB Manual - Manual (Page 24)

24 www.closystems.com
“C1”, “C2”, “C3” or “C4” is displayed on control box
Normally X-arm ™ will show the code associated with the TV mounted on it.
1. Check that the IR receiver is plugged into the side of the X-
arm ™ and that the IR Receiver eye is in direct line of sight
with the remote control.
2. Make sure that the code set on the control box is the correct
code for the TV width mounted.
Code TV Outside Width
C1 40” - 44.9” (102 - 113 cm)
C2 45” - 48.9” (114 - 123 cm)
C3 49” - 55.9” (124 - 140 cm)
C4 56” - 63.0” (142 - 160 cm)
If the code is incorrect, reset the width code.
2-1. Press the power switch to ON (1).
2-2. Measure the total outside width of the TV including any side speakers that may
be attached to the TV. Do not use the TV manufacturer’s screen size, which is
measured diagonally, to set the TV width on X-arm™.
2-3. Insert the provided plastic pointer into the selector hole, and press the button until
the TV width code corresponds to the outside width of your TV as indicated in the
table below.
Code TV Outside Width
C1 40” - 44.9” (102 - 113 cm)
C2 45” - 48.9” (114 - 123 cm)
C3 49” - 55.9” (124 - 140 cm)
C4 56” - 63.0” (142 - 160 cm)
2-4. Hold the black rubber set button, below the selector hole, until the TV width code
stops blinking.
3. Check that the TV and X-arm ™ are not trapped against the wall or any other object.
4. Plug in X-arm ™, turn on the power and try to move the X-arm ™ using the remote control.
If it works properly, do not continue to the next step.
5. I nsert the provided plastic pointer into the Selector hole on the side of X-arm™, and
press the button until a “t” is shown.
6. Using the remote control, straighten X-arm ™ so that it is parallel with the wall and then
press the Set button on the control box for three seconds. X-arm ™ will return to the
home position.
7. Unplug X-arm ™ and plug it in again.
Set
Power Switch
Control Box
LED Display
Selector
Set Button