WallWizard X700CB Manual - Manual (Page 8)

8 www.closystems.com
7. Route the Cables and IR Receiver
X-arm is designed to hide cables and the TV power cord by passing them through the bellows to
the wall. Use the cable-separating features built into X-arm™ to keep the power and AV cables
separated to minimize electrical interference and binding as X-arm™ moves.
If the TV power outlet is located outside the bellows of X-arm™, follow the directions below.
If the power outlet for your TV and X-arm™ is located inside the bellows, go to page 9.
7-1. Run A/V cables over the bottom cross bar, through a cable loop and down through the
cable hole in the back of the X-arm.
7-2. Run the TV power cord on the other side the same way.
7-3. Unplug the IR Receiver and run the plug end up over the bottom cross bar, through a
cable hook and out the cable hole. Plug the IR Receiver back into the side of X-arm™.
7-4. The AV, power cord, and IR Receiver cords must be long enough to connect equipment,
but not so long that they get caught in X-arm™ parts. Test this by tilting up, down, and
side to side.
7-5. Using the provided zip ties, fasten all cables to the Cable Bar located near the Cable Hole.
7-6. Using the provided zip ties, fasten the cables to the Bottom Cross Bar so that they pass
over the cross bar. The cables should be at least 2” (5 cm) from the center beam. Cut off
the excess zip tie ends.
AV Cables
to TV
AV Cables from
Component
TV Power Outlet
(outside bellows)
Power
to TV
IR Reciever Eye
IR Reciever
Plug
Cable Loops
Bellows
No Cable
2” (5 cm)
No Cable
2” (5cm)
Cable Bar
Bottom Cross Bar
Cable Hole
Cable Tie Anchor