WallWizard X700CB Manual - Manual (Page 27)

www.closystems.com 27
TV does not fit X-arm
1. Make sure that the TV is not too large or heavy for X-arm:
Maximum TV outside width accomodated: 40” - 63” (102 - 160 cm)
Maximum weight limit: 180 lbs. (81 kg)
2. If mounting holes on TV back are too wide or narrow, an optional adapter may be
needed.
TV leans forward at the home position (not parallel with wall)
Possible Causes:
The weight of the TV is causing the X-arm to lean forward in the home position.
How to Correct:
1. Move X-arm to the home position, against the wall, by pressing the IN button on the
remote once.
2. Insert the provided plastic pointer into the Selector hole on the side of the X-arm control
box and press the button until the display reads HP.
3. Using the up and down arrow buttons on the remote, adjust the X-arm to the position
where the TV is parallel with the wall.
4. Press the Set button on the side of the X-arm for 3 seconds.
5. The X-arm will now go to the new home position you just programmed every time you
select the IN button for it to go home.
Maintenance
1. Remove the TV from X-arm ™ yearly to check that no cords are inteferring with moving
parts.
•